Машина для тиснения фольгой Brausse 1050 SFF

Paper (depending on quality), min. : 80 – 90 g/m2
Carton (depending on quality), up to : 600 g/m2
Corrugated board (Fine), up to : 4 mm
(*) Admissible undulation: 4% of the sheet width
Minimal gripper edge : 9.5 mm
Foil Stamping System
Four servo motor driven foil advancing shafts each individually programmable for short and long foil stepping 99 programmable short pull per shaft
Each foil advancing shaft is equipped with a holographic foil print mark reading photo sensor.
Industrial PC holographic foil stamping to print register system with manual register tolerance compensation device.
Free standing operation console with industrial pc, Pro – Face touch screen and 12 thermometers
for foil advancing step setting and temperature control with machine pre-heating timer
Draw type foil roll bracket for loading foil outside at operation side
Foil lead through bar
450 turning bar
Specifications for die cutting:
Maximum die cutting size: 1040 x 730 mm
Inner size of chase: 1145 x 755 mm
Dimensions die cutting plate: 1080 x 736 mm
Maximum die cutting pressure: 300 T
Maximum mechanical speed: 7500 cycles/hour
Foil splitting blade Heating base with 12 heating zone each temperature adjustable individually
Foil breaking control
Warning system for remaining foil
Oil cooled tension control shaft
Foil separating air blaster with air volume, blasting strength per zone and starting and ending time adjustment
Thin paper stretching air blaster with air volume, blasting strength per zone and starting and ending time adjustment
A/C motor driven inverter-controlled brush rollers waste foil ejecting and foil tension system
Category: Hot Foil Stamper
Marke: Brausse